Digital technologies have already reshaped large parts of prosthodontics from design to fabrication, bringing greater efficiency, precision and patient comfort. Yet one key question remains unresolved: how close are we to a truly end-to-end digital workflow for removable dentures? In this edition of “Ask the experts”, Frauke Müller, Martin Schimmel, Benedikt Spies and Nicola U. Zitzmann share their perspectives on where digital workflows stand today – and where critical gaps persist.
Good question! From a production point of view, we are already fully digital, be it by milling or by rapid prototyping. CAD/CAM resins are equally biocompatible, show better shock absorption and have a very hygienic surface. Patients are delighted with the comfort of the well-fitting and thin palatal plate. In early experiments, we measured an average thickness of 1.7 mm in CAD/CAM versus 2.6 mm in conventional palatal plates, a difference well noted by patients. A recent systematic review published in the JPD (Avelino et al. 2024) evinced a tendency towards higher patient satisfaction with milled dentures than with printed ones (n.s.). In the same review, however, compared to conventional manufacturing techniques, denture retention was significantly higher with printed dentures, which was not the case for the milled ones (n.s.). These results refer, however, to the manufacturing process, and not impression-taking.
“The digital impression of the edentulous jaw provides excellent accuracy for the hard palate and the alveolar ridges, as the contact-free scan does not deform the tissues.”
The digital impression of the edentulous jaw provides excellent accuracy for the hard palate and the alveolar ridges, as the contact-free scan does not deform the tissues. There is no bad taste, nausea, or gag reflex. However, without analog border-molding and a potsdam compression, the retention of digital impressions is still falling short (Chebib et al. 2024), and white esthetics are still judged to be more favorable with pre-fabricated denture teeth (Stilwell 2021). As for the state of the art in 2026, analog border molding is incorporated into the digitally manufactured try-in denture before the final prosthesis is produced.